CLI Guide

• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
ip ip-address (OPTIONAL) Enter the keyword ip then the IP address of
the ARP entry you wish to clear.
no-refresh (OPTIONAL) Enter the keywords no-refresh to delete the
ARP entry from CAM. Or use this option with interface or
ip ip-address to specify which dynamic ARP entries you
want to delete.
NOTE: Transit traffic may not be forwarded during the
period when deleted ARP entries are resolved again and
re-installed in CAM. Use this option with extreme
caution.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4094 VLANs on the E-Series (the prior
limit was 2094).
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
762
IPv4 Routing