CLI Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Related
Commands
• show interfaces — display the ARP timeout value for all available interfaces.
clear arp-cache
Clear the dynamic ARP entries from a specific interface or optionally delete (no-refresh) ARP entries
from the content addressable memory (CAM).
Syntax
clear arp-cache [vrf vrf-name | interface | ip ip-address] [no-
refresh]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of
the VRF to clear the ARP cache corresponding to that VRF.
interface (OPTIONAL) Enter the following keywords and the interface
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information.
• For a port channel interface, enter the keywords port-
channel
then a number.
IPv4 Routing
761