CLI Guide

Version Description
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage Information This command is found on the Management interface only.
Related
Commands
• interface ManagementEthernet — configure the Management port on the
system (either the Primary or Standby RPM).
• management route — configure a static route that points to the Management
interface or a forwarding router.
stack-unit portmode
Convert a single 100G port into two 50G ports, one 40G port, four 25G ports, or four 10G ports..
Syntax
stack-unit stack-unit-number port number portmode {dual speed
50G | quad speed {25G | 10G} | single speed 40G} [no-confirm]
Parameters
stack-unit Enter the stack member unit identifier of the stack member
to reset.
number Enter the port number of the port to be split. The total
number of ports are 32. The range is from 1 to 32.
single Convert a single 100G port into one 40G port.
dual Split a single 100G port into two 50G ports.
quad Split a single 100G port into four 10G or 25G ports.
no-confirm (OPTIONAL) Enter the keywords no-confirm to reset any
previous configuration and apply the new configuration
immediately. If you this option, the system does not prompt
you to confirm the deletion of any existing configuration.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Added support for dynamically fanning-out of interfaces on
S6000. Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
Interfaces
737