CLI Guide

Example
Dell#show system stack-unit 1 fanout configured
Configured fan out ports in stack-unit 1
Port Mode Speed
1 Dual 50G
2 Quad 10G
3 Quad 10G
4 Single 40G
5 Quad 25G
8 Single 40G
10 Single 40G
11 Single 40G
12 Single 40G
13 Quad 25G
16 Single 40G
17 Single 40G
18 Dual 50G
19 Quad 10G
20 Quad 10G
27 Single 40G
28 Dual 50G
29 Single 40G
32 Dual 50G
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode
interfaces’ IEEE 802.1Q tag status and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-
id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the
interface information:
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a backup interface for this interface, enter the
keyword backup.
stack-unit unit-id (OPTIONAL) Enter the keywords stack-unit then the
stack member number.
726
Interfaces