CLI Guide

!
interface TenGigabitEthernet 1/1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-te-1/1/1-1/1/2)#
show interfaces
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface-type
Parameters
interface Enter one of the following keywords and the interface
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For stack-units, enter the keywords stack-unit then
the slot/port information.
• For a Null interface, enter the keyword null then the
Null interface number.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
712
Interfaces