CLI Guide

• speed (Management interface) — Set the speed for the Management interface.
interface null
Configure a Null interface on the switch.
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not configured; number = 0
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information You cannot delete the Null interface. The only configuration command possible in
a Null interface is ip unreachables.
Example
Dell(conf)# interface null 0
Dell(conf-if-nu-0)#
Related
Commands
• interface — configure a physical interface.
• interface loopback — configure a Loopback interface.
• interface port-channel — configure a port channel.
• interface vlan — configure a VLAN.
Interfaces
691