CLI Guide

• interface port-channel — configure a port channel.
• interface vlan — configure a VLAN.
interface managementEthernet
Configure the Management port on the system (either the Primary or Standby RPM).
Syntax
interface managementEthernet slot/port
Parameters
slot/port
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP
address to the Management port, use the ip address command.
Example
Dell(conf)# interface managementethernet 1/1
Dell(conf-if-ma-1/1)#
Related
Commands
• management route — configure a static route that points to the Management
interface or a forwarding router.
690
Interfaces