CLI Guide

• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a tunnel interface, enter the keyword tunnel. The
range is from 1 to 16383.
vrrp [ipv6 {vr-id} |
vr-id]
(OPTIONAL) Enter the keyword vrrp to clear the counters
of all VRRP groups. To clear the counters of VRRP groups
on all IPv6 interfaces, enter ipv6. To clear the counters of a
specified group, enter a VRID number from 1 to 255.
learning-limit (OPTIONAL) Enter the keywords learning-limit to clear
unknown source address (SA) drop counters when MAC
learning limit is configured on the interface.
vlan vlan-id Enter the keyword vlan followed by the interface VLAN
number. The range is from 1 to 4094.
Defaults Without an interface specified, the command clears all interface counters.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.4.1.0 Added support (E-Series only) for VRRP groups in a VRF
instance.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added support for 4093 VLANs on the E-Series. Prior to the
release, 2094 was supported.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Interfaces
675