CLI Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on S-Series and Z–Series.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not
yield results.
debug ip igmp snooping
Enable debugging of IGMP snooping packets on interfaces and groups.
Syntax
debug ip igmp snooping [group address | interface]
• To disable debugging of IGMP snooping, use the no debug ip igmp
snooping [group address | interface] command.
• To disable all debugging, use the undebug all command.
Parameters
snooping Enter the keyword snooping to enable debugging of IGMP
snooping.
group-address (OPTIONAL) Enter the IP multicast group address in dotted
decimal format.
interface interface Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
664
Internet Group Management Protocol (IGMP)