CLI Guide

Version Description
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.5.1.0 Introduced on the E-Series.
show ip igmp groups
View the IGMP groups.
Syntax
show ip igmp [vrf vrf-name] groups [group-address [detail] |
detail | interface [group-address [detail]]]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF to configure this setting on that VRF.
group-address (OPTIONAL) Enter the group address in dotted decimal
format to view information on that group only.
interface (OPTIONAL) Enter the interface type and the interface
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number.
656
Internet Group Management Protocol (IGMP)