CLI Guide

16
Flex Hash and Optimized Boot-Up
This chapter describes the Flex Hash and fast-boot enhancements.
load-balance ingress-port enable
Enable the Flex hash functionality. This utility is supported on the platform.
Syntax
load-balance ingress-port enable
To disable the Flex hash capability, use the no version of this command.
Default None
Command Modes CONFIGURATION mode
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.3(0.0) Introduced on the S6000 platform.
9.2(1.0) Introduced on the Z9500.
Usage Information Flex hash uses the RTAG7 bins 2 and 3 (overlay bins). These bins must be enabled
for Flex hash to be configured. These bins contain the source module and source
port information. These bins are disabled by default in releases of Dell Networking
OS earlier than Release 9.3.0.0. The default behavior of disabling of these bins
occurs because of incorrect egress port information that would otherwise be
displayed in the output of the diagnostic show command of show ip flow.
As a result, when load balancing of RRoCE packets using Flex hash is enabled, the
show ip flow command is not functional. Similarly, when show ip flow
command operates (ingress port based load balancing is disabled) the hashing of
RRoCE packets is not operational.
Flex hash APIs do not mask out unwanted byte values after extraction of the data
from the Layer 4 headers for the offset value.
Example
Dell#load-balance ingress-port enable
598
Flex Hash and Optimized Boot-Up