CLI Guide

Parameters
ipv6 acl Enter the keyword ipv6 acl to select IPv6 ACL data.
stack-unit
number
Enter the keywords stack-unit then a number to select a
stack ID. The range is from 1 to 6.
port-set 0–0 Enter the keyword port-set with a port-pipe number. The
range is from 0 to 0.
pipeline pipeline-
number
Enter the keyword pipeline with a pipeline number to
display the MAC ACL entries specific to the pipeline number.
The range is from 0 to 3.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
show hardware stack-unit
Display the data plane or management plane input and output statistics of the designated component of
the designated stack member.
Syntax
show hardware stack-unit stack-unit-number {cpu {data-plane
statistics | i2c statistics | management statistics | party-bus
statistics | sata-interface statistics} | drops [unit unit-
number] | fpga registers | stack-port stack-port-number | unit
unit-number {counters | details | ipmc-replication | port-stats
[detail] | register | table-dump table-name}}
Parameters
stack-unit stack-
unit-number
{command-
option}
Enter the keywords stack-unit to select a particular stack
member and then enter one of the following command
options to display a collection of data based on the option
entered. The range is from 1 to 6.
Debugging and Diagnostics
531