CLI Guide

support for automatic partitioning. Level 2 diagnostics are
used primarily for on-board loopback tests and more
extensive component diagnostics. Various components on
the board are put into Loopback mode and test packets are
transmitted through those components. These diagnostics
also perform snake tests using VLAN configurations.
verbose Enter the keyword verbose to run the diagnostic in
Verbose mode. Verbose mode gives more information in
the output than Standard mode.
no-reboot Enter the keyword no-reboot to prevent the system from
rebooting after the test. To bring the stack unit to online
state, use the online stack-unit stack-unit-number
command.
interactive Enter the keyword interactive with the test ID to test
interactive test cases. The test cases can be found using the
show diag testcase stack-unit stack-unit-id
interactive command.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced the verbose option.
7.7.1.0 Introduced on the S-Series.
offline stack-unit
Place a stack unit in the offline state.
Syntax
offline stack-unit number
522
Debugging and Diagnostics