CLI Guide

show interface dcbx detail
Displays the DCBX configuration on an interface.
Syntax
show interface port-type slot/port[/subport] dcbx detail
Parameters
port-type Enter the port type.
slot/port[/subport] Enter the slot/port number. Enter the subport number if a
40G port is fanned-out into 10G ports.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.9(0.0) Added support to display the interface configurations
corresponding to a range of ports.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Down status messages added.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To clear DCBX frame counters, use the clear dcbx counters interface
stack-unit/port command.
The following describes the show interface dcbx detail command shown in
the following example.
Field Description
Interface Interface type with chassis slot and port number.
Port-Role Configured the DCBX port role: auto-upstream, auto-
downstream, config-source, or manual.
DCBX Operational
Status
Operational status (enabled or disabled) used to elect a
configuration source and internally propagate a DCB
configuration. The DCBX operational status is the
combination of PFC and ETS operational status.
Data Center Bridging (DCB)
505