CLI Guide

clear ets counters
Clear all ETS TLV counters on an interface.
Syntax
clear ets counters port-type slot/port[/subport]
Parameters
port-type Enter the keywords port-type then the slot/port
information. Enter the subport number if a 40G port is
fanned-out into 10G ports.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
show interface ets
Displays the ETS configuration applied to egress traffic on an interface, including priority groups with
priorities and bandwidth allocation.
Syntax
show interface port-type slot/port[/subport] ets {summary |
detail}
Parameters
port-type slot/
port[/subport] ets
Enter the port-type slot and port ETS information. Enter the
subport number if a 40G port is fanned-out into 10G ports.
{summary | detail} Enter the keyword summary for a summary list of results or
enter the keyword detail for a full list of results.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.9(0.0) Added support to display the interface configurations
corresponding to a range of ports.
498
Data Center Bridging (DCB)