CLI Guide

Example
(Summary)
Dell(conf)#show interfaces tengigabitethernet 1/13/2 pfc statistics
Interface TenGigabitEthernet 1/13/2
Interface Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
-----------------------------------------------------------------------------------------------
Te 1/13/2 P0 0 0 0
Te 1/13/2 P1 0 0 0
Te 1/13/2 P2 0 0 0
Te 1/13/2 P3 0 0 0
Te 1/13/2 P4 0 0 0
Te 1/13/2 P5 0 0 0
Te 1/13/2 P6 0 0 0
Te 1/13/2 P7 0 0 0
Dell(conf)#
ETS Commands
The following ETS commands are supported on the Dell Networking OS.
dcb-enable
Enable data center bridging.
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb
enable command. The range is from 1 or 4.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
• dcb <ets | pfc> enable — enable priority flow control or enhanced transmission
selection on interface.
Data Center Bridging (DCB)
497