CLI Guide

Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the
S6000-ON.
9.4.(0.0) Added support for PBR and VRF.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Clarified block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-
dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
Save the new CAM settings to the startup-config (write-mem or copy run
start) then reload the system for the new settings to take effect.
The total amount of space allowed is 13 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. Only 9 number of blocks can be
configured by the user .
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any configuration
changes that have changed the NVRAM content, use the command reload
conditional nvram-cfg-change
.
cam-acl-egress
Allocate CAM for egress ACLs.
Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl
number
Parameters
default Reset egress CAM ACL entries to default settings.
Content Addressable Memory (CAM)
475