CLI Guide

Parameters
default Use the default CAM profile settings and set the CAM as
follows:
• L2Acl : 2
• Ipv4Acl : 2
• Ipv6Acl : 0
• Ipv4Qos : 2
• L2Qos : 2
• L2PT : 0
• IpMacAcl : 1
• VmanQos : 0
• EtsAcl : 0
• FcoeAcl : 0
• ipv4pbr : 0
• vrfv4Acl : 0
• Openflow : 0
• fedgovacl : 0
• nlbclusteracl: 0
l2acl number Enter the keyword l2acl and then the number of l2acl
blocks. The range is from 0 to 8 in multiples of 2.
ipv4acl number Enter the keyword ipv4acl and then the number of FP
blocks for IPv4. The range is from 0 to 9 in multiples of 3,
when ipv4udfenable is selected. If not enabled, it is in
multiples of 2.
ipv6acl number Enter the keyword ipv6acl and then the number of FP
blocks for IPv6. The range is from 0 to 9 in multiples of 3.
ipv4qos number Enter the keyword ipv4qos and then the number of FP
blocks for IPv4. The range is from 0 to 8 in multiples of 2.
l2qos number Enter the keyword l2qos and then the number of FP blocks
for l2 qos. The range is from 0 to 8 in multiples of 2.
l2pt number Enter the keyword l2pt and then the number of FP blocks
for l2 protocol tunnelling. The range is from 0 to 8 in
multiples of 2.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP
blocks for IP and MAC ACL. The range is from 0 to 9.
etsaclnumber Enter the keyword etsacl and then the number of FP
blocks for ETS ACL. The range is from 0 to 9.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of
FP blocks for nlbcluster ACL. The range is from 0 to 9. By
default, the value is 0 and it supports 8 NLB arp entries
reserved for internal functionality.
Content Addressable Memory (CAM)
473