CLI Guide

• ? = (question mark) sequences in a pattern (either zero
or one sequences).
NOTE: Enter an escape sequence (CTRL+v) prior to
entering the ? regular expression.
• [ ] = (brackets) a range of single-character patterns.
• ( ) = (parenthesis) groups a series of pattern elements
to a single element.
• { } = (braces) minimum and the maximum match
count.
• ^ = (caret) the beginning of the input string. If you use
the caret at the beginning of a sequence or range, it
matches on everything BUT the characters specified.
• $ = (dollar sign) the end of the output string.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp regexp command shown in the
following example.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then non-BGP routes exist in the
router’s routing table.
Metric Displays the BGP router’s metric, if assigned.
460
Border Gateway Protocol