CLI Guide

ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the
keyword unicast to view information related only to ipv6
unicast routes.
peer-group-name (OPTIONAL) Enter the name of a peer group to view
information about that peer group only.
detail (OPTIONAL) Enter the keyword detail to view detailed
status information of the peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status
information of the peers in that peer group. The output is
the same as that found in the show ip bgp summary
command.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the
S4810 shows the ADDPATH parameters.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The following describes the show ip bgp peer-group command shown in the
following example.
Line beginning
with:
Description
Peer-group Displays the peer group’s name.
Administratively
shut
Displays the peer group’s status if the peer group is not
enabled. If you enable the peer group, this line is not
displayed.
458
Border Gateway Protocol