CLI Guide

Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The show ip bgp community-list command without any parameters lists BGP
routes matching the Community List and the output is the same as for the show
ip bgp
command output.
The following describes the show ip bgp community-list pass command
shown in the following example.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is
listed in this column, then local routes exist in the routing
table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
Path Lists all the ASs the route passed through to reach the
destination network.
Example
Dell# conf t
Dell(conf)# ip community-list cl1
Dell(config-community-list)# permit 1000:1
Dell(config-community-list)# end
Dell# show ip bgp community-list cl1
436
Border Gateway Protocol