CLI Guide

Version Description
7.7.1.0 Introduced on the C-Series.
Usage Information Loopback interfaces are up constantly and the BGP session may need one
interface constantly up to stabilize the session. The neighbor update-source
command is not necessary for directly connected internal BGP sessions.
Neighbors are sorted according to the source and destination ip addresses. If an
update-source ip address exists, then the source ip address determines the order in
which the neighbors are displayed.
neighbor weight
Assign a weight to the neighbor connection, which is used to determine the best path.
Syntax
neighbor {ip-address | peer-group-name} weight weight
To remove a weight value, use the no neighbor {ip-address | peer-
group-name} weight command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal
format.
peer-group-name Enter the name of the peer group to disable all routers
within the peer group.
weight Enter a number as the weight. The range is from 0 to 65535.
The default is 0.
Defaults 0
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Border Gateway Protocol
417