CLI Guide

extended (OPTIONAL) Enter the keyword extended to send extended
community attribute.
standard (OPTIONAL) Enter the keyword standard to send standard
community attribute.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information To configure a COMMUNITY attribute, use the set community command in
ROUTE-MAP mode.
In order that settings corresponding to the neighbor send-community
command take effect, you must execute the clear ip bgp command
immediately after you execute the neighbor send-community command.
If you do not set any of the optional parameters (standard or extended), then both
standard as well as extended attributes are sent. If you set either the standard or
extended parameter, only the attribute that is specified is sent.
neighbor shutdown
Disable a BGP neighbor or peer group.
Syntax
neighbor {ip-address | peer-group-name} shutdown
To enable a disabled neighbor or peer group, use the neighbor {ip-address |
peer-group-name}no shutdown command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
412
Border Gateway Protocol