CLI Guide

Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-name Enter the name of the peer group to set the default route of
all routers in that peer group.
route-map map-
name
(OPTIONAL) Enter the keyword route-map then the name
of a configured route map.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you apply a route map to a BGP peer or neighbor with the neighbor default-
originate command configured, the software does not apply the set filters in the
route map to that BGP peer or neighbor.
When you configure a route-map for a BGP peer or peer group with the neighbor
default-originate command, the command checks for the existence of the
route in BGP RIB.
Route-map configuration on a BGP peer or peer group works only when the LOC-
RIB contains at least one route.
When you apply a default route to a BGP peer or peer group using the neighbor
default-originate command, changes to the configured default route-map
are applied to the BGP peer or peer group only after a delay of 15 seconds. As a
result, you must wait for a period of 15 seconds before manually resetting BGP
using the
clear ip bgp command.
394
Border Gateway Protocol