CLI Guide

ignore enable-password
Reload the system software without the enable password configured.
Syntax ignore enable-password
Command Modes BOOT_USER
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage Information
When you enter the reload command and the system reboots, you will not be
prompted for a password to enter the EXEC Privilege mode (normally you are
required to enter the enable command).
If your console or Telnet session expires after you used the ignore enable-
password command, you are prompted for an enable password when you re-
establish the session
Related
Commands
reload — Exit from this mode and reload FTOS.
ignore startup-config
During a reload, do not load the startup-config file.
Syntax ignore startup-config
Defaults disabled
Command Modes BOOT_USER
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Usage Information
Use this command if you have authentication procedures in the startup-config
other than the enable-password setting.
338
Boot Command Line Interface