CLI Guide

boot write net config retries
Set the number of retries for network boot configuration failure.
Syntax boot write net config retries <int>
Command Modes BOOT_USER
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.0.2.0 Introduced on the S6000.
Example
BOOT_USER # boot write net config retries 2
Updated number of Network Boot Config retries to 2
BOOT_USER #
boot zero
Erase the configured primary, secondary, or default boot image parameters. If you erase all three
parameters, the S6000 switch boots from its internal Flash.
Syntax boot zero primary | secondary | default}
Parameters
primary
Enter the keyword primary to configure the boot
parameters used in the first attempt to boot the system.
secondary
Enter the keyword secondary to configure boot parameters
used if the primary operating system boot selection is not
available.
default
Enter the keyword default to configure boot parameters
used if the secondary operating system boot parameter
selection is not available. You can configure this option to
any of the available type, for example flash/usb/ftp/tftp.
Defaults None
Command Modes BOOT_USER
Boot Command Line Interface
335