CLI Guide

NOTE: When you specify a single VRF, use the name of
the VRF instead of the VRF ID number. Use the VRF ID
numbers only when you specify a range of VRFs.
optimized (OPTIONAL) Enter the keyword optimized to enable ACL
optimization
Defaults Not enabled.
Command Modes INTERFACE/VRF MODE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information You can assign one ingress ACL and one egress ACL to an interface.
NOTE: If you apply outbound(egress) IP acl on a switch port, the filter applies
only for routed traffic egressing out of that port.
To associate an access-list to a non-default VRF, use the vrf attribute of this
command. You can use this command at the interface context (physical/LAG) to
apply the access-list to a range of VRFs.
The VRF MODE is not available for the default and management VRFs.
Related
Commands
• ip access-list standard — configure a standard ACL.
Access Control Lists (ACL)
195