CLI Guide

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan, and then
the VLAN ID. The VLAN ID range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to subtract from
the priority value. The range is from 1 to 254. The default is
10.
Defaults priority cost = 10
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
If you disable the interface, the cost value is subtracted from the priority value and
forces a new MASTER election if the priority value is lower than the priority value in
the BACKUP virtual routers.
virtual-address
Configure up to 12 virtual router IP addresses in the VRRP group. To start sending VRRP packets, set at
least one virtual IP address for the VRRP group.
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-
address1 [... ip-address12] command.
1736
Virtual Router Redundancy Protocol (VRRP)