CLI Guide

show vrrp
View the VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns No
Active VRRP group.
Syntax
show vrrp [vrrp-id][brief][interface type][ipv6][interface type][vrf
vrf-name]
Parameters
vrrp-id (OPTIONAL) Enter the virtual router identifier for the VRRP group to
view only that group. The range is from 1 to 255.
brief (OPTIONAL) Enter the keyword brief to view a table of information
about the VRRP groups.
interface type (OPTIONAL) Enter the following keywords and the interface
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE
then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan, and then the VLAN
ID. The VLAN ID range is from 1 to 4094.
ipv6 (OPTIONAL) Enter the keyword ipv6 to view only VRRP IPv6 groups.
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to
view active VRRP groups corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the
relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1732
Virtual Router Redundancy Protocol (VRRP)