CLI Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
debug vrrp
Enable VRRP debugging.
Syntax
debug vrrp [vrrp-id] {all | bfd | database | interface | ipv6 |
packets | state | timer}
To disable debugging, use the no debug vrrp [vrrp-id] {all | bfd |
database | interface | ipv6 | packets | state | timer} command.
Parameters
vrrp-id (OPTIONAL) Enter a number from 1 to 255 as the VRRP
group ID.
all Enter the keyword all to enable debugging of all VRRP
groups.
bfd Enter the keyword bfd to enable debugging of VRRP BFD
interactions.
database Enter the keyword database to enable debugging of
configuration changes.
interface Enter the following keywords and the interface information:
• For Port Channel interface types, enter the keywords
port-channel then the number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
Virtual Router Redundancy Protocol (VRRP)
1725