CLI Guide

Version Description
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the support for IPV6 / IPV4.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
peer-routing-timeout
Configure the delay after which peer routing disables when the peer is unavailable. This command is
applicable for both IPv6 and IPv4.
Syntax
peer-routing-timeout value
To restore the default value, use the no peer-routing-timeout command.
Parameters
value Enter the timeout value (in seconds). The range is from 1 to
65535. The default value is infinity.
Command Modes VLT DOMAIN (conf-vlt-domain)
Default Infinity
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Added support for default value on the S-Series and Z-
Series.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the support for IPV6 / IPV4.
9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
9.0.2.0 Introduced on the S6000.
Usage Information When the timer expires, the software checks to see if the VLT peer is available. If
the VLT peer is not available, peer-routing disables on that peer.
Virtual Link Trunking (VLT)
1707