CLI Guide

proxy-gateway static
Enables the proxy-gateway feature using static configurations.
Syntax
[no] proxy-gateway static
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000.
Usage Information
When you add a proxy-gateway static configuration, the setting is saved in the
Layer 2 module. When you remove the static proxy gateway configuration, each
proxy-gateway static MAC configured is deleted from the Layer 2 module.
Example
Dell(conf)# vlt-domain 1
Dell(conf-vlt-domain)# proxy-gateway static
Dell(conf-vlt-domain)#
remote-mac-address exclude-vlan
Configure the proxy-gateway static entry and exclude a VLAN or a range of VLANs from proxy routing.
Syntax
[no] remote-mac-address mac—address [exclude-vlan vlan-range]
Parameters
remote-mac-
address
Specify the mac-addresses of the VLT peers which are in the
remote VLT domain.
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn
format.
vlan-range
Enter the VLAN IDs in which proxy gateway is not needed.
The VLANs are excluded from doing proxy gateway. The
VLT Proxy Gateway
1693