CLI Guide

The export-target and import-target support only the match the protocol and
prefix-list options. Other options that you configure in the route-maps are ignored.
Related
Commands
• ipv6 route-export — exports IPv6 routes to another VRF.
match source-protocol
Specify matching source-protocol criteria while exporting or importing routes.
Syntax
match source-protocol {bgp | isis | ospf | connected | static}
Parameters
bgp Enter the keyword bgp to leak or share routes
corresponding to the BGP protocol.
isis Enter the keyword isis to leak or share routes
corresponding to the ISIS protocol.
ospf Enter the keyword ospf to leak or share routes
corresponding to the OSPF protocol.
connected Enter the keyword connected to leak or share connected
routes corresponding to the VRF.
static Enter the keyword static to leak or share static routes
corresponding to the VRF.
Command Modes ROUTE MAP MODE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–
ON, and Z9500.
Usage Information
Specify the matching criteria only after defining a route-map. Before using this
command, you must enter Route Map mode using the route-map route-map-
name command. The match criteria that you specify is associated with the route-
map that you define.
1686
Virtual Routing and Forwarding (VRF)