CLI Guide

There must be no prior Layer 3 configuration on the interface when configuring
VRF.
You must enable VRF before using this command.
You can configure an IP subnet or address on a physical or VLAN interface that
overlaps the same IP subnet or address configured on another interface only if the
interfaces are assigned to different VRFs. If you assign two interfaces to the same
VRF, you cannot configure overlapping IP subnets or the same IP address to them.
Example
Dell# configure terminal
Dell(conf)# ip vrf red
Dell(conf-vrf)# description "Red Network"
Dell(conf-vrf)# show config
!
ip vrf red 4
description "Red Network"
Dell(conf-vrf)#
Dell(conf-if-te-1/4/1)# int te 1/4/2
Dell(conf-if-te-1/4/2)# no shut
Dell(conf-if-te-1/4/2)# ip vrf forwarding red
Dell(conf-if-te-1/4/2)# ip add 100.1.1.1/24
Dell(conf-if-te-1/4/2)#
Dell(conf-if-te-1/4/2)#
Dell(conf-if-te-1/4/2)#
Dell(conf-if-te-1/4/2)# show config
!
interface TenGigabitEthernet 1/4/2
ip vrf forwarding red
ip address 100.1.1.1/24
no shutdown
Dell(conf-if-te-1/4/2)#
ip http vrf
Configure an HTTP client with a VRF used to connect to the HTTP server.
Syntax
ip http vrf {management | vrf-name}
To undo the HTTP client configuration, use the ip http vrf command.
Parameters
management Enter the keyword management for configuring the
management VRF that uses an HTTP client.
vrf-name Enter a VRF name that the HTTP client uses. If you do not
specify a VRF name, the HTTP client uses the default VRF.
Defaults Disabled
1680
Virtual Routing and Forwarding (VRF)