CLI Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
Usage Information Enable DEI before using this command.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible
command in its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface Enter the following keywords and the interface information:
• For a Port Channel interface, enter the keywords port-
channel, and then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
Defaults Not configured.
Command Modes CONF-IF-VLAN
VLAN Stacking
1667