CLI Guide

ntp server
Configure an NTP time-serving host.
Syntax
ntp server[vrf vrf-name] {hostname | ipv4-address | ipv6-
address} [key keyid] [prefer] [version number]
Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the
VRF to configure an NTP time-serving host corresponding
to that VRF.
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)
of NTP server.
hostname Enter the host name of the server.
key keyid (OPTIONAL) Enter the keyword key and a number as the
NTP peer key. The range is from 1 to 4294967295.
prefer (OPTIONAL) Enter the keyword prefer to indicate that this
peer has priority over other servers.
version number (OPTIONAL) Enter the keyword version and a number to
correspond to the NTP version used on the server. The
range is from 1 to 4.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.6(0.0) Added support for VRF.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added IPv6 support.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
System Time and Date
1643