CLI Guide

Defaults level = 6 or informational
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
• logging trap — limit messages logged to the Syslog servers based on severity.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple
logging servers of both IPv4 and/or IPv6 can be configured.
Syntax
logging {ip-address | ipv6-address | hostname} {{udp {port}} |
{tcp {port}} [vrf vrf-name]
To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
hostname Enter the name of a host already configured and recognized
by the switch.
Simple Network Management Protocol (SNMP) and Syslog
1579