CLI Guide

Parameters
enable Enter the keyword enable to enable password-
authentication for the SSH server.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information With password authentication enabled, you can authenticate using the local,
RADIUS, or TACACS+ password fallback order as configured.
ip ssh rekey
Configures the time rekey-interval or volume rekey-limit threshold at which to re-generate the SSH key
during an SSH session.
Syntax
ip ssh rekey [time rekey-interval] [volume rekey-limit]
To reset to the default, use no ip ssh rekey [time rekey-interval]
[volume rekey-limit] command.
Parameters
time minutes Enter the keywords time then the amount of time in
minutes. The range is from 10 to 1440 minutes. The default
is 60 minutes
Security
1495