CLI Guide

• 100 Mb/s Ethernet interface = 200000
• 1-Gigabit Ethernet interface = 20000
• 10-Gigabit Ethernet interface = 2000
• Port Channel interface with one 100 Mb/s Ethernet =
200000
• Port Channel interface with one 1 Gigabit Ethernet =
20000
• Port Channel interface with one 10 Gigabit Ethernet =
2000
• Port Channel with two 1 Gigabit Ethernet = 18000
• Port Channel with two 10 Gigabit Ethernet = 1800
• Port Channel with two 100 Mbps Ethernet = 180000
edge-port Enter the keywords edge-port to configure the interface
as a rapid spanning tree edge port.
bpduguard
(OPTIONAL) Enter the keyword portfast to enable
Portfast to move the interface into Forwarding mode
immediately after the root fails.
Enter the keyword bpduguard to disable the port when it
receives a BPDU.
shutdown-on-
violation
(OPTIONAL) Enter the keywords shutdown-on-violation
to hardware disable an interface when a BPDU is received
and the port is disabled.
priority priority Enter keyword priority then a value in increments of 16
as the priority. The range is from 0 to 240. The default is
128.
loopguard Enter the keyword loopguard to enable loop guard on an
RSTP port or port-channel interface.
rootguard Enter the keyword rootguard to enable root guard on an
RSTP port or port-channel interface.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1420
Rapid Spanning Tree Protocol (RSTP)