CLI Guide

Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the network command
specifies.
offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in |
out} offset [interface] command.
Parameters
prefix-list-name Enter the name of an established Prefix list to determine
which incoming routes are modified.
offset Enter a number from zero (0) to 16 to be applied to the
incoming route metric matching the access list specified. If
you set an offset value to zero (0), no action is taken.
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
1376
Routing Information Protocol (RIP)