CLI Guide

distribute-list out
Configure a filter for outgoing routing updates.
Syntax
distribute-list prefix-list-name out [interface | bgp |
connected | isis |ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out
command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
connected (OPTIONAL) Enter the keyword connected to filter only
directly connected routes.
isis (OPTIONAL) Enter the keyword isis to filter only IS-IS
routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF
routes.
static (OPTIONAL) Enter the keyword static to filter manually
configured routes.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
1368
Routing Information Protocol (RIP)