CLI Guide

wred Specify WRED curve parameters for a queue.
green Specify green (low) drop precedence to a queue.
weight Specify a weight factor to a queue.
yellow Specify yellow (medium) drop precedence to a queue.
pool0 Service-pool buffer 1 (default service-pool for PFC traffic) .
pool1 Service-pool buffer 0 (default service-pool for both lossy
and lossless traffic. traffic).
number Enter a weight for the queue as a number in the range of 1
to 15. This parameter applies only if you specify the green or
yellow drop precedence.
string Enter the WRED profile name. It is a string of up to 32
characters. Or use one of the five pre-defined WRED profile
names. Pre-defined Profiles: wred_drop, wred-ge_y,
wred_teng_y, wred_teng_. This parameter applies only if
you specify a weight factor.
Default All queues on backplane ports operate in tail-drop (best-effort traffic) mode by
default. There is no default WRED green or yellow profile. The default weight is 0.
Command Modes CONFIGURATION mode
Command History
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3.0.0 Introduced on the S6000 and Z9000 platforms
Usage Information
You can configure only service pool 0. The pool, service0, is used for lossy queues.
A WRED profile contains a set of attributes, such as the minimum and maximum
threshold values, and the maximum drop rate for the received packets. You can
add or remove WRED parameter configurations for one or more shared service
pools using a single command. The service-pool wred command is similar in
usage and working to the
service-class bandwidth-percentage queue-id
command.
Example
Dell(conf-wred) #wred thresh-1
Dell(conf-wred) #threshold min 100 max 200 max-drop-rate 40
Dell(conf-wred) #wred thresh-2
Dell(conf-wred) #threshold min 300 max 400 max-drop-rate 80
Dell(conf) #service-pool wred green pool0 thresh-1 pool1
thresh-2
Quality of Service (QoS)
1353