CLI Guide

Commands

• rate-shape — shapes traffic output as part of the designated policy.

service-class dynamic dot1p

Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all

interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE

mode entry.

Syntax

service-class dynamic dot1p

To return to the default setting, use the no service-class dynamic dot1p

command.

Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class

dynamic dot1p command. The default mapping is as follows:

dot1p Queue ID

0 1

1 0

2 2

3 3

4 4

5 5

6 6

7 7

Command Modes

• INTERFACE

• CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

Quality of Service (QoS)

1303