CLI Guide

reload
Reboot the system.
Syntax
reload [conditional nvram-cfg-change]
Parameters
conditional
nvram-cfg-
change
(OPTIONAL) Reload into the Dell Networking Operating
System (OS) if the condition is true. A configuration change
to the NVRAM requires a switch reload. To reload the
switch, select nvram-cfg-change.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
9.1(0.0) Added ‘conditional’ parameter.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
If you use only the reload command, the system boots into the Dell Networking
OS.
If there is a change in the running configuration, the system prompts you to save
the new configuration when you reload the system using the reload command.
You can also save your running configuration manually using the copy running-
config command.
You can use the conditional parameter if any configuration changes made to
the NVRAM, such as, stack-group and fanout configurations, must be saved.
Control and Monitoring
127