CLI Guide

monitor multicast-queue 7
Dell#
Related
Commands
• monitor session — creates a monitoring session.
• show monitor session — displays a monitoring session.
source (port monitoring)
Configure a port monitor source.
Syntax
source {interface | range | any} destination interface
direction {rx | tx | both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
Parameters
source interface Enter one of the following keywords and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port/subport
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE then the slot/port/subport
information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE then the slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE then the slot/port information.
• For a VLAN interface enter the keyword VLAN followed
by a number from 1 to 4094.
• For a port channel interface, enter the keywords port-
channel
then a number.
range Enter the keyword range to specify the list of interfaces.
any Enter the keyword any to specify all interfaces.
NOTE: This option is applicable only with drop monitor
session.
destination Enter the keyword destination to specify the destination
interface.
1268
Port Monitoring