CLI Guide

To remove an RP address, use the no ip pim [vrf vrf-name] rp-address
address {group-address group-address mask} [override] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
address Enter the RP address in dotted decimal format (A.B.C.D).
group-address
group-address
mask
Enter the keywords group-address then a group-address
mask, in dotted decimal format (/xx), to assign that group
address to the RP.
override Enter the keyword override to override the BSR updates
with static RP. The override takes effect immediately during
enable/disable.
NOTE: This option is applicable to multicast group
range.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information First-hop routers use this address by to send register packets on behalf of source
multicast hosts. The RP addresses are stored in the order in which they are entered.
PIM-Sparse Mode (PIM-SM)
1243