CLI Guide

To return to the default, use the no ip pim [vrf vrf-name] register-
filter access-list command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
access-list Enter the name of an extended access list. Maximum 16
characters.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced
Usage Information The access name is an extended IP access list that denies PIM register packets to
RP at the source DR based on the multicast and group addresses. Do not enter this
command before creating the access-list.
ip pim rp-address
Configure a static PIM rendezvous point (RP) address for a group or access-list.
Syntax
ip pim [vrf vrf-name] rp-address address {group-address group-
address mask} [override]
1242
PIM-Sparse Mode (PIM-SM)