CLI Guide

Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF to permit or deny PIM join or prune messages on
an interface associated with that VRF.
ext-access-list Enter the name of an extended access list.
in Enter the keyword in to apply the ACL filter to in-bound
traffic.
out Enterthe keyword out to apply the ACL filter to out-bound
traffic.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Removed the in and out parameters. Introduced on the
S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-
Series.
7.7.1.0 Introduced on the E-Series.
Example
Dell(conf)# ip access-list extended iptv-channels
Dell(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24
Dell(config-ext-nacl)# permit ip any 232.1.1.0/24
Dell(config-ext-nacl)# permit ip 100.1.1.0/16 any
Dell(config-ext-nacl)#
Related
Commands
• ip access-list extended — configure an access list based on IP addresses or
protocols.
PIM-Sparse Mode (PIM-SM)
1239