CLI Guide

To remove the DR priority value assigned, use the no ip pim dr-priority

command.

Parameters

priority-value Enter a number. Preference is given to larger/higher

number. The range is from 0 to 4294967294. The default is

Defaults 1

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series.

7.8.1.0 Introduced on the C-Series on port-channels and the S-

Series.

Usage Information The router with the largest value assigned to an interface becomes the designated

router. If two interfaces contain the same designated router priority value, the

interface with the largest interface IP address becomes the designated router.

ip pim join-filter

Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command

prevents the PIM-SM router from creating state based on multicast source and/or group.

Syntax

ip pim [vrf vrf-name] join-filter ext-access-list [in | out]

To remove the access list, use the no ip pim [vrf vrf-name] join-filter

ext-access-list command.

1238

PIM-Sparse Mode (PIM-SM)