CLI Guide

Policy-based Routing (PBR)

Policy-based routing (PBR) allows you to apply routing policies to specific interfaces. To enable PBR,

create a redirect list and apply it to the interface. After the redirect list is applied to the interface, all traffic

passing through the interface is subject to the rules defined in the redirect list. PBR is supported by the

Dell Networking OS.

You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or

virtual local area network [VLAN]). Trace lists and redirect lists do not function correctly when you

configure both in the same configuration.

NOTE: Apply PBR to Layer 3 interfaces only.

NOTE: For more information , see Content Addressable Memory (CAM).

ip redirect-group

Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an

interface by entering this command multiple times.

Syntax

ip redirect-group redirect-list-name

To remove a redirect list from an interface, use the no ip redirect-group

name command.

Parameters

redirect-list-name Enter the name of a configured redirect list.

Defaults None

Command Modes INTERFACE (conf-if-vl-)

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

Policy-based Routing (PBR)

1221